Remember that you may only need to move your cursor up or down slightly to correct the color. In the picture below, I’ve selected the following area:įrom where you clicked, drag your cursor up to add more of the channel’s color (in this case, blue) and down for the color’s opposite (yellow) and thus correct the image’s tone. Then, click an area on your image that has too much of one of the colors on the curve. Then, for the most precise results, click the color selector icon next to the channels above the tone curve. Click the channel with the colors you’d like to correct: the red channel has red and teal, the green channel has green and purple, and the blue channel has blue and yellow. As the opposite of yellow is blue, we will work on the blue channel for the above image. Once you identify the color, you’ll need to use the tone curve to add more of this color’s opposite. In the below image, some areas have a yellow hue (likely because the photo was taken with low lighting coming from lamps). Figure out which color is most prominent in this area. To use the tone curve to edit the image’s white balance, first, you’ll need to look at the area of your image that seems to have the most unnatural color tone. You can find the tone curve under the Tone Curve tab. The tone curve allows you to adjust the different tones of a picture - from the exposure settings (highlights, shadows, whites, and blacks) to the specific color tones in an image. The other method to adjust the white balance in an image is to use the Tone Curve. To re-do your selection, click the eyedropper icon again and choose another area of the image to base your white balance adjustment. You can also adjust the Tint toggle to add more purple or green hues. Drag to the left to cool the image (adding more of a blue hue) and to the right to add warmth (more of a yellow hue). You can further adjust the white balance if you’d like by dragging the Temp toggle along the bar. A box will appear, allowing you to pick a target neutral from the area you’ve clicked for the most accurate selection.Ĭhoose the area that should be pure white, as once you click, Lightroom will automatically adjust the rest of the image based on your selection. For the example below, I’ll click the wall, as the wall was white when I shot the photo. Now, click an area on your image that should be white. Rather than clicking the toggles to change the white balance, click the eyedropper icon to the left. To do this, head to the Develop module and then the Basic tab.Īt the top of the Basic tab, you’ll see the white balance bars (WB) made up of the Temp and Tint sliders. While you can easily adjust the white balance of the entire photo, there is a simple way to get a more accurate correction using the white balance selector.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |